Does git checkout readwrite7/25/2023 ![]() ![]() If no -b option is given, the name of the new branch will be derived from the remote-tracking branch, by looking at the local part of the refspec configured for the corresponding remote, and then stripping the initial part up to the "*". ![]() When creating a new branch, set up "upstream" configuration. This is equivalent to running "git branch" with "-f" see git-branch for details. B Ĭreates the branch and start it at if it already exists, then reset it to. b Ĭreate a new branch named and start it at see git-branch for details. "our shared canonical history"), while what you did on your side branch as theirs (i.e. As the keeper of the canonical history, you need to view the history from the remote as ours (i.e. This is because rebase is used in a workflow that treats the history at the remote as the shared canonical one, and treats the work done on the branch you are rebasing as the third-party work to be integrated, and you are temporarily assuming the role of the keeper of the canonical history during the rebase. Note that during git rebase and git pull -rebase, ours and theirs may appear swapped -ours gives the version from the branch the changes are rebased onto, while -theirs gives the version from the branch that holds your work that is being rebased. When checking out paths from the index, check out stage #2 ( ours) or #3 ( theirs) for unmerged paths. When checking out paths from the index, do not fail upon unmerged entries instead, unmerged entries are ignored. This is used to throw away local changes and any untracked files or directories that are in the way. When switching branches, proceed even if the index or the working tree differs from HEAD, and even if there are untracked files in the way. This flag enables progress reporting even if not attached to a terminal, regardless of -quiet. Progress status is reported on the standard error stream by default when it is attached to a terminal, unless -quiet is specified. See below for the description of -patch option. This is similar to the previous mode, but lets you use the interactive interface to show the "diff" output and choose which hunks to use in the result. With -m, changes made to the working tree file can be discarded to re-create the original conflicted merge result. The contents from a specific side of the merge can be checked out of the index by using -ours or -theirs. Using -f will ignore these unmerged entries. By default, if you try to check out such an entry from the index, the checkout operation will fail and nothing will be checked out. The index may contain unmerged entries because of a previous failed merge. When the is given, overwrite both the index and the working tree with the contents at the. When the (most often a commit) is not given, overwrite working tree with the contents in the index. Overwrite the contents of the files that match the pathspec. git checkout … git checkout -pathspec-from-file= Omitting detaches HEAD at the tip of the current branch. would check out that branch without detaching HEAD). When the argument is a branch name, the -detach option can be used to detach HEAD at the tip of the branch ( git checkout Local modifications to the files in the working tree are kept, so that the resulting working tree will be the state recorded in the commit plus the local modifications. Prepare to work on top of, by detaching HEAD at it (see "DETACHED HEAD" section), and updating the index and the files in the working tree. That is to say, the branch is not reset/created unless "git checkout" is successful. ![]()
0 Comments
Leave a Reply. |